We're looking for beta testers.

Guide

Troubleshooting

Fix common Edge and setup issues, or contact support.

Edge not sending data

  1. Confirm the Pi has power and the network LED activity looks normal.
  2. In the app, check whether the monitor is offline. Compare with your organization upload interval on Billing (see Upload interval).
  3. Open the Edge locally at http://orbimon-edge.local (or http://<edge-ip>:8080) and verify it shows a healthy link to the dish and Orbimon.
  4. Re-enter the monitor token in Edge settings if you rotated it in the app.
  5. An owner or admin can issue a new monitor token from the monitor page.

Setup Wi-Fi Orbimon-Setup-XXXX not visible

  • Wait at least one to two minutes after power-on.
  • Move closer to the Pi and refresh the Wi-Fi list.
  • If the Edge was used before, it may be on your LAN instead of setup mode. Try http://orbimon-edge.local or factory reset (see Install Orbimon Edge).
  • Factory reset the Edge, rejoin Orbimon-Setup-XXXX, and open http://10.42.0.1/setup.
  • Prefer Ethernet to the Starlink router if Wi-Fi is unreliable.
  • Ensure the chosen network is the one your Starlink dish uses.

Monitor token rejected

  • Copy the full token including the omb_mon_ prefix with no extra spaces.
  • Tokens are monitor-specific. Use the token from the monitor you created.
  • If the token was rotated, paste the new token on the Edge.

Charts empty but monitor online

  • Short gaps are normal after reboots or network changes.
  • Try a shorter time range. Very new monitors need a minute for the first points.
  • Check Events and outages for disconnects.

Charts update late

  • Check status.orbimon.com. If Orbimon is running on its fallback region, recent charts may update with a short delay.
  • Your Orbimon Edge keeps sending data as usual. You don't need to change anything.

Get help

Email support@orbimon.com with your organization name, monitor name, and what you already tried. Do not send monitor tokens or API secrets in email.

See also